Multitech MultiVOIP 100 MVP120 Guía de usuario descargar pdf (Pagina 38)

MultiVOIP Quick Start Guide

Remote Site Administrator

1. Connect one end of the power supply to a live AC outlet

and connect the other end to the Power connection on

your MultiVOIP.

Figure 4. Remote Site Cable Connection

2. Connect a network cable to the ETHERNET 10Base-T

(RJ-45) connector on the back of your MultiVOIP.

3. If you are connecting to a PSTN or PBX/FXO port,

connect one end of an RJ-11 cable to the Phone

connector on the back of the MultiVOIP and the other end

to the PSTN or PBX/FXO port.

4. Turn on power to the MultiVOIP by placing the ON/OFF

switch on the right side panel in the ON position. Wait for

the Boot LED on the MultiVOIP to go off before

proceeding. This may take a couple of minutes.

5. At this time your VOIP network should be fully operational.

Dial one of the sites in your network using the dialing

directory supplied by your Network Administrator.

1 2 ... 33 34 35 36 37 38 39 40

Sin comentarios

Multitech MultiVOIP 100 MVP120 Guía de usuario Pagina 38