Multitech MTA128ST-USB Guía de usuario descargar pdf (Pagina 40)

MultiMobile

USB

User Guide

Command: \Q

Flow Control Selection

Values:

= 0, 1, or 3

Default: 3

Description: \Q0 Disable flow control (same as

&K0

\Q1 XON/XOFF software flow control (same as

&K4

\Q2 CTS-only flow control. Not supported.

\Q3 RTS/CTS hardware flow control (same as

&K3

Command: \T

Inactivity Timer

Values:

= 0, 1–255

Default: 0

Description: \Tn Sets the time (in minutes) after the last character is sent or received that the modem waits be-

fore disconnecting. A value of zero disables the timer. Applies only in buffer mode.

Note: You can also set the inactivity timer by changing the value of

S30

Command: \V

Protocol Result Code

Values:

= 0, 1, or 2

Default: 1

Description: \V0 Disable the appending of the protocol result code to the DCE speed.

\V1 Enable the appending of the protocol result code to the DCE speed.

\V2 Same as

\V1

Command: \X

XON/XOFF Pass-Through

Values:

= 0 or 1

Defaults: 0

Description: \X0 Modem responds to and discards XON/XOFF characters.

\X1 Modem responds to and passes XON/XOFF characters.

Command: -C

Data Calling Tone

Values:

= 0 or 1

Defaults: 0

Description: -C0 Disable V.25 data calling tone to deny remote data/fax/voice discrimination.

-C1 Enable V.25 data calling tone to allow remote data/fax/voice discrimination.

Command: %A Adaptive Answer Result Code Enable

Values: n = 0 or 1

Defaults: 0

Description: The

command controls whether the

DATA

and

FAX

result codes will be sent by the modem.

The modem must be in fax mode for this command to work. Also, the modem must be set to

+FAA=1 which enables the modem to distinguish between a fax and a data call. When these

commands are enabled, the modem sends

DATA

to the computer when it detects data tones

and

FAX

when it detects fax tones. These strings are used by some servers to select the appro-

priate communication program.

%A0 Disables adaptive answer result codes.

%A1 Enables adaptive answer result codes.

Command: %B View Numbers in Blacklist

Values: n/a

Description: If blacklisting is in effect, AT%B displays the numbers for which the last call attempted in the

previous two hours failed. In countries that do not require blacklisting, the

ERROR

result code

appears.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 83 84

Comentarios a estos manuales

Sin comentarios

Multitech MTA128ST-USB Guía de usuario Pagina 40

Comentarios a estos manuales

Relacionado con productos y manuales para Módems Multitech MTA128ST-USB