Multitech MultiModem MT5634ZBA-V-V92 Guía de usuario descargar pdf (Pagina 31)

Multi-Tech Systems, Inc. MT5634ZBA-Series User Guide (S000286H) 31

Appendix C – Regulatory

Compliance

FCC Part 15 Regulation

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the

FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will

not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Plug the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC rules. Operation of this device is subject to the following conditions: (1) This

device may not cause harmful interference, and (2) this device must accept any interference that may cause undesired

operation.

WARNING – Changes or modifications to this unit not expressly approved by the party responsible for compliance could void

the user’s authority to operate the equipment.

FCC Part 68 Telecom

1. This equipment complies with Part 68 of the Federal Communications Commission Rules. On the outside surface of this

equipment is a label that contains, among other information, the FCC registration number. This information must be

provided to the telephone company.

2. The suitable USOC jack (Universal Service Order Code connecting arrangement) for this equipment is shown below. If

applicable, the facility interface codes (FIC) and service order codes (SOC) are shown.

3. An FCC-compliant telephone cord and modular plug is provided with this equipment. This equipment is designed to be

connected to the telephone network or premises wiring using a compatible modular jack that is Part 68 compliant.

4. The ringer equivalence number (REN) is used to determine the number of devices that may be connected to the

telephone line. Excessive RENs on the telephone line may result in the device not ringing in response to an incoming

call. In most, but not all, areas the sum of the RENs should not exceed 5.0. To be certain of the number of devices that

may be connected to the line, as determined by the total RENs, contact the local telephone company.

5. If this equipment causes harm to the telephone network, the telephone company will notify you in advance that temporary

discontinuance of service may be required. But if advance notice is not practical, the telephone company will notify you

as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary.

6. The telephone company may make changes in its facilities, equipment, operations, or procedures that could affect the

operation of the equipment. If this happens, the telephone company will provide advance notice in order for you to make

necessary modifications in order to maintain uninterrupted service.

7. If trouble is experienced with this equipment (the model of which is indicated below) please contact Multi-Tech Systems,

Inc. at the address shown below for details of how to have repairs made. If the trouble is causing harm to the telephone

network, the telephone company may request you remove the equipment from the network until the problem is resolved.

8. No repairs are to be made by you. Repairs are to be made only by Multi-Tech Systems or its licensees. Unauthorized

repairs void registration and warranty.

9. This equipment should not be used on party lines or coin lines.

10. If so required, this equipment is hearing aid compatible.

11. Manufacturer: Multi-Tech Systems, Inc.

Trade Name: MultiModem ZBA

Model Number: MT5634ZBA

FCC Registration No: AU7USA-24713-M5-E

Ringer Equivalence: 0.3B

Modular Jack (USOC): RJ11C or RJ11W (single line)

Service Center in USA: Multi-Tech Systems, Inc.

2205 Woodale Drive

Mounds View, MN 55112 U.S.A.

(763) 785-3500 Fax (763) 785-9874

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 41 42

Comentarios a estos manuales

Sin comentarios

Multitech MultiModem MT5634ZBA-V-V92 Guía de usuario Pagina 31

Comentarios a estos manuales

Relacionado con productos y manuales para Módems Multitech MultiModem MT5634ZBA-V-V92