Multitech MTCBA-G-F2 Manual de usuario descargar pdf (Pagina 18)

Chapter 3 – SMTP/POP3 Email Services

Multi-Tech Systems, Inc. AT Commands for Wireless Modems with IP Connectivity (S000333D) 18

#REC1, REC1ADD / REC2, REC2ADD / REC3, REC3ADD Set Email Address

Definition: To send email messages, the TCP/IP stack software must know the e-mail address of the recipient.

This email address will appear in the email header sent by the TCP/IP stack software, in the field ‘To:‘

The RECi parameter can hold a maximum of 10 email addresses, each email address being at the most

120 characters long.

Values: RECi (i = 1, 2, or 3)

Alphanumeric ASCII text string up to 120 characters. The address must be provided in literal format (for

instance [email protected]). No default.

Setting One Email Address / Resetting the Parameter / Getting:

Set value / reset the parameter: AT#RECi="Value" (replace i with 1, 2, or 3)

Get value: AT#REC? (replace i with 1, 2, or 3) or AT#VMAILi, AT#VALL

Setting One to Ten Email Address to the RECi Parameter / Resetting the Parameter:

To set 1 to 10 email addresses to the RECi parameter, enter the AT#RECiADD<CR> overwriting

command.

Each email address has to be an alphanumeric ASCii text string, in literal format (for instance,

dev12345678@web.xyz). To add another email address, enter the <CRLF> pair. To end the setting,

enter the following character: 1A (in ASCII code), generated in a keyboard by CTRL+Z escape

sequence.

Note1: This command overwrites all previously set email addresses of the RECi parameter.

Note2: If more than ten addresses are entered, the 11

and subsequent addresses until the end

character will be ignored.

Example: AT#REC1ADD<CR>

[email protected]<CRLF>

<CTRL+Z>

#SUBJ1 / SUBJ2 / SUBJ3 Set Email Pre-Defined Subject Text

Definition: These parameters contain the pre-defined subject text that will be used by the TCP/IP stack to compose

the email header.

Values: Alphanumeric ASCII text string up to 120 characters. No default.

Syntax: Set Value: AT#SUBJi=<value> (replace i with 1, 2, or 3)

Get Value: AT#SUBJi? (replace i with 1, 2, or 3) or AT#VMAILi, AT#VALL

#BODY1 / BODY2 / BODY3 Set Pre-Defined Email Combinations

Definition: These parameters store pre-defined message bodies. They allow the host application to send pre-

defined email combinations.

Values: The body content has to be entered after the AT#BODY1<CR> command. It has to be an alphanumeric

ASCII text string up to 120 characters followed this character: 1A (in ASCII code) and generated on a

keyboard by CTRL+Z. No default.

Syntax: Set Value: AT#BODYi=<value> (replace i with 1, 2, or 3)

Get Value: AT#BODYi? (replace i with 1, 2, or 3) or AT#VMAILi, AT#VALL

Example: AT#BODY1<CR>

Text string

<CTRL+Z>

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 77 78

Comentarios a estos manuales

Sin comentarios

Multitech MTCBA-G-F2 Manual de usuario Pagina 18

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Multitech MTCBA-G-F2