Multitech RF310E Guía de usuario descargar pdf (Pagina 13)

Chapter 2 - Installation

RF300E/RF310E 13

Cabling Your RASFinder

Cabling your RASFinder involves making the proper WAN, Ethernet, Command Port, and Power

connections. Figure 2-2 shows the back panel connectors and the associated cable connections.

The procedures for connecting the cables to your RASFinder are provided below.

Power Connection

Ethernet Connection

COMMAND

10BASET

POWER

BRI 3 BRI 2 BRI 1

WAN Connections

Figure 2-2. Back Panel Connections

Note: If additional RAM is needed, perform the procedure in the next section, Adding Additional RAM.

The following steps detail the procedures for connecting the cables to your RASFinder.

1 Connect the RASFinder to a PC using the short RJ-45 to DB9 (female) cable provided with the unit.

Plug the RJ-45 end of the Command cable into the Command Port of the RASFinder and the other

end into the PC's serial port. See Figure 2-2.

2 Connect an RJ-45 (UTP) cable to the 10 BASE-T connector on the back of the RASFinder. Connect

the other end of the cable to your LAN.

3 Connect one end of a UTP cable to each of the BRI Connectors on the RASFinder (labeled BRI 1,

BRI 2, and BRI 3) and connect the other end to a WAN jack (as shown in Figure 2-2).

4 Connect one end of the power supply to a live AC outlet, then connect the other end to the

RASFinder as shown in Figure 2-2. The power connector is a 6-pin circular DIN connector.

5 Turn on power to the RASFinder by setting the ON/OFF switch on the back panel to the ON position.

At this time your RASFinder is completely cabled.

Proceed to the next section to install the RASFinder software.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 198 199

Sin comentarios

Multitech RF310E Guía de usuario Pagina 13