Multitech MA100-1M Manual de usuario

MultiAccess® ACS Analog Communications Server MA220 MA420 MA820 Quick Start Guide

Quick Start Guide 4. Enter the E-mail address of the administrator in the Administrator E-mail window. 5. If the SMTP Server requires an User ID, en

MultiAccess ACS 11Modem Configuration There are two primary ways to use the modems; RAS and Modem Sharing. Prior to software release version 1.03,

Quick Start Guide 1. Select the desired Modem Sharing by clicking on the down arrow and highlighting your usage. No Authentication. Immediate acc

MultiAccess ACS 5. If the modem usage is Modem Sharing and the calls are in-bound, click the on option for the Caller ID. 6. Click Update for Modem C

Quick Start Guide 14 When the authentication method is Radius, then the IP address and UDP port of the Radius Server and Radius Accounting Server have

MultiAccess ACS 8. Repeat the above procedure for POTS modem 2 on the MA220, POTS modems 2 through 4 on the MA420, or POTS modems 2 through 8 on the

Quick Start Guide 16 Caution: If you change the password, you must be sure you remember your new password. 4. If the administrator account is goin

MultiAccess ACS 17

Patents This device is covered by one or more of the following patents: 6,031,867; 6,012,113; 6,009,082; 5,905,794; 5,864,560; 5,815,567; 5,81

MultiAccess ACS 2 MultiAccess ACS Quick Start Guide MA220, MA420, MA820 P/N 82100102L, Revision C All rights reserved. This publication may not be re

MultiAccess ACS Introduction This guide shows you how to setup your MultiAccess ACS analog communication server, two-port model MA220, four-port model

Quick Start Guide 4 We Supply • One MultiAccess unit with factory-installed software • Two rack mounting brackets and four mounting screws for MA420

MultiAccess ACS 5Safety Recommendations for Rack Instructions • Ensure proper installation of the MultiAccess in a closed or multi-unit enclosure

Quick Start Guide MA220 Mechanical Mounting (Optional) The MA220 comes with chassis screw holes to facilitate attaching it to a flat surface. Vers

MultiAccess ACS Cabling Procedure - Back Panel Cabling your MultiAccess involves making the proper power, phone, and ethernet connections as described

Quick Start Guide 8 3. Continue to connect standard telephone cables to the remaining RJ11 jacks on the back of the MultiAccess. 4 The Command or CON

MultiAccess ACS Setting MultiAccess IP Addresses 1. In the MultiAccess Administration screen, go to the IP Configuration fields. 2. Fill in the IP