Multitech RF802USB Guía de usuario descargar pdf (Pagina 10)

Chapter 1 - Introduction

Multi-Tech Systems, Inc. Wireless Network Adapter User Guide 10

Setup 4 – The Home Internet Network with a Residential Gateway, Firewall,

or Router

Use This Setup If:

You have two or more computers and/or laptops and want to share files, printers,

and Internet access using a Residential Gateway, Router, or Firewall

You want to connect to an Ethernet network that uses Dynamic (DHCP) IP addresses.

This setup requires a 1) a Wireless Router or an Access Point and 2) an Ethernet

capable Gateway, Router, or Firewall or an existing Ethernet network.

Additional Requirements:

These setup directions are intended for Network Administrators with Dynamic IPs.

This type of setup requires that your residential Gateway, Router, Firewall, or

Network Administrator give you a dynamic IP address for each computer.

You will also have to setup your Access Point. Consult Access Point documentation its

installation procedures.

Steps:

1. Using the Ethernet cable provided with your router, connect the router to the

Cable/DSLmodem.

2. Connect the Access Point to the Router.

3. Install the Wireless Network Adapter - See the Installation section of this

guide or the Quick Start Guide.

4. Check the wireless connection - See Configuration Utility and Networking

Basics.

5. Check the IP Address for the wireless adapter - See Networking Basics.

Note: The default settings for the Wireless Network Adapter are set to obtain

a Dynamic IP Address.

6. Learn to share printers and files - See Networking Basics.

PC with wireless

connection

to another PC

Cable Modem

PC with wireless USB Adapter

connected to an access point

Wireless

Access Point

LINE

LINELINE

Broadband

Gateway

The Home Internet Network with a Residential Gateway, Firewall, or Router

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 57 58

Sin comentarios

Multitech RF802USB Guía de usuario Pagina 10