Multitech MVP100GK Especificaciones descargar pdf (Pagina 8)

Installation

8 Multi-Tech Systems, Inc. Gatekeeper Quick Start Guide

Unpacking

Check the items on the Gatekeeper shipping list to ensure that you have

received the correct options and accessories. Unpack the unit and inspect it

for visible shipping damage. If damage is observed, do not power-on the unit;

contact Multi-Tech's Tech Support for advice. If no damage is observed, place

the Gatekeeper in its final location.

Cabling

Cabling your Gatekeeper entails making the proper connections for power,

command port, and Ethernet network. The below figure shows the back

panel connectors and the associated cable connections. The following

procedure details the steps necessary for cabling your Gatekeeper.

1. Connect the power cord to a live AC outlet, then connect it to the

Gatekeeper’s power receptacle shown at top right in below figure.

2. Connect the Gatekeeper to the PC (the computer that will hold the

Gatekeeper software) using the RJ-45 to DB9 (female) cable provided

with your unit. Plug the RJ-45 end of the cable into the Command port

of the Gatekeeper and connect the other end (the DB9 connector) to

the PC serial port you are using (typically COM1 or COM2).

3. Connect a network cable to the Ethernet connector on the back of the

Gatekeeper. Connect the other end of the cable to your network.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 24 25

Sin comentarios

Multitech MVP100GK Especificaciones Pagina 8