Multitech MVP100GK Especificaciones descargar pdf (Pagina 9)

Installation

Multi-Tech Systems, Inc. Gatekeeper Quick Start Guide 9

4. If you intend to configure the Gatekeeper remotely using the

Gatekeeper Windows GUI, connect an RJ-11 phone cable between the

Command Modem connector (at the rear of the Gatekeeper) and a

receptacle served by a telco POTS line. See below figure.

The Command Modem is built into the Gatekeeper unit. To configure the

Gatekeeper remotely using its Windows GUI, you must call into the

Gatekeeper’s Command Modem. Once a connection is made, the

configuration process is identical to local configuration with the Windows

GUI.

Figure. GND & Remote Config Modem Connections

5. Ensure that the unit is properly connected to earth ground by verifying

that it is reliably grounded when mounted within a rack.

This can be accomplished by connecting a grounding wire between the

chassis grounding screw (see above figure) and a metallic object that

will provide an electrical ground.

6. Turn on power to the Gatekeeper by setting the power switch on the

right side panel to the ON position. Wait for the Boot LED on the

Gatekeeper to go off before proceeding. This may take a couple of

minutes.

Proceed to Loading Gatekeeper Software section.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 24 25

Sin comentarios

Multitech MVP100GK Especificaciones Pagina 9