Multitech MULTI MODEM II MT5600BA Manual de usuario descargar pdf (Pagina 69)

6 Callback Security

MultiModemII User Guide

7. Press the Enter button again to go to the CALLBACK NUMBER screen.

8. Press à, à to go to the ENTER NUMBER #2? screen.

9. Repeat steps 3–7 to enter the next number.

10. Repeat as many times as necessary, up to memory location 30, until all numbers

have been entered.

Warning: There is no way to review an entry to confirm that it has been entered cor-

rectly. If you attempt to look at a number entry by pressing the Enter button for an

ENTER NUMBER #n? screen, it is possible for you to accidentally erase the entry.

Calling Procedure

Use the following procedure to call a modem that has callback security enabled.

Note: Autoanswer must be enabled on the calling modem (S0=1 or S0=2).

1. Using a data communication program such as HyperTerminal, dial the number

of the callback modem.

2. When the connection is established, the callback modem responds with a re-

quest for a password.

3. Type the password for your modem, and then press ENTER. You have three at-

tempts to enter a valid password or be disconnected.

4. If the password is valid, the callback modem disconnects. Then, after a short

delay, it calls the number associated with the password and establishes a work-

ing connection.

Note: If you are calling a direct connect number, you must append a hyphen (-) to

the password. If the corresponding phone number has - as its first character, you

will be able to go directly online with the callback modem. If the corresponding

phone number has no - character, you will be prompted for a different password.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 112 113

Sin comentarios

Multitech MULTI MODEM II MT5600BA Manual de usuario Pagina 69