Multitech MT9234ZPX-UPCI Guía de usuario descargar pdf (Pagina 29)

Appendix B – Regulatory Compliance

Multi-Tech Systems, Inc. MT9234ZPX User Guide 29

Protection Against Contact with TNV Circuit

The protective cover is fastened to the modem card by means that will only allow a tool to remove the

cover.

Warning: Removal of the protective cover will affect product safety and user safety requirements.

EMC, Safety, and R&TTE Directive Compliance

The CE mark is affixed to this product to confirm compliance with the following European Community

Directives:

• Council Directive 89/336/EEC of 3 May 1989 on the approximation of the laws of Member States

relating to electromagnetic compatibility;

and

• Council Directive 73/23/EEC of 19 February 1973 on the harmonization of the laws of Member

States relating to electrical equipment designed for use within certain voltage limits;

and

• Council Directive 1999/5/EC of 9 March 1999 on radio equipment and telecommunications terminal

equipment and the mutual recognition of their conformity.

New Zealand Telecom Warning Notice

1. The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has

accepted that the item complies with minimum conditions for connection to its network. It indicates

no endorsement of the product by Telecom, nor does it provide any sort of warranty. Above all, it

provides no assurance that any item will work correctly in all respects with another item of

Telepermitted equipment of a different make or model, nor does it imply that any product is

compatible with all of Telecom’s network services.

This equipment is not capable under all operating conditions of correct operation at the higher speed

which it is designated. 33.6 kbps and 56 kbps connections are likely to be restricted to lower bit rates

when connected to some PSTN implementations. Telecom will accept no responsibility should

difficulties arise in such circumstances.

2. Immediately disconnect this equipment should it become physically damaged, and arrange for its

disposal or repair.

3. This modem shall not be used in any manner which could constitute a nuisance to other Telecom

customers.

4. This device is equipped with pulse dialing, while the Telecom standard is DTMF tone dialing. There

is no guarantee that Telecom lines will always continue to support pulse dialing.

Use of pulse dialing, when this equipment is connected to the same line as other equipment, may

give rise to ‘bell tinkle’ or noise and may also cause a false answer condition. Should such problems

occur, the user should not contact the Telecom Faults Service.

The preferred method of dialing is to use DTMF tones, as this is faster than pulse (decadic) dialing

and is readily available on almost all New Zealand telephone exchanges.

5. Warning Notice: No ‘111’ or other calls can be made from this device during a mains power failure.

6. This equipment may not provide for the effective hand-over of a call to another device connected to

the same line.

7. Some parameters required for compliance with Telecom’s Telepermit requirements are dependent

on the equipment (PC) associated with this device. The associated equipment shall be set to operate

within the following limits for compliance with Telecom’s Specifications:

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 38 39

Comentarios a estos manuales

Sin comentarios

Multitech MT9234ZPX-UPCI Guía de usuario Pagina 29

Comentarios a estos manuales

Relacionado con productos y manuales para Módems Multitech MT9234ZPX-UPCI