Multitech MT56DSU-R Manual de usuario descargar pdf (Pagina 8)

MT932 thru MT2834 modems

To communicate asynchronously with modem, set switches:

3,7,8,9,11,12,15 Down; All other switches up.

Synchronous operation,(used with a mux) set switches:

3,9,11 Down, all others up.

ZDX modem - Set initially for factory defaults -AT&F then set the $mb and $sb to match serial port baud

andAT&E13then at&wto writethe options

MT56DSU modem -DDS synchronous multiplexor operation

19.2k-switches1,4,13,16down,all othersup

56k -switches 4,13,16 down, all others up

MT64DSU modem -DDS synchronous multiplexor operation

19.2k- switch 1 up, all others down

56k- switch 2 up, all others down

64k- swiches 1,2 up, allothers down

-------------------------------------------------------------------------------------------------------------------------------

* Modems connected to computer serial ports must have the serial baud rate set to match the computer

baud rate. The command is AT$SBxxxxx, where xxxxx is baud rate.

* Modems that will be used for Electronic Claims should have Pacing turned off (AT&EI2) andData

Compression turned off (AT&EI4).

* Dialup modems should have their main baud rate no higher than 19200. Command is AT$MBI9200.

* Store phone number in modem. ATDT"phone number"Nx stores "phone number" in position x of the

phone number memory in modem.

* Dial stored phone number, ATNx dials the phone number at position x in phone number storage.

* DTR dialing- Modem dials phone number stored at position zero in phone number storage whenDTR

becomes true. Command = AT$D1.

* Dialup modems used with multiplexors should be set for factory defaults, then change main baud rate to

no greater than 19200 baud. The remote site modem should be set for DTR dialing and main site

phone number set in phone number storage positon O(zero).

{

* To check or change options to a remote modem dial in and when you get connected type %%%at,this

will give you the option of data or command mode, select command and enter the password of

MODEMSETUP, (must be caps) this connects you in command mode just like having a terminal

directly connected to the modem. when finished type atO (capital 0) and will take you back.

* Any modem that is used for Support or ECS should not be configured as an Automatic Call Unit (ACU)

in the /usr/lib/uucp/Devices file. UUCP will change the settings of an ACU defined modem and can .

mess up ECS and Support communication.

1 2 3 4 5 6 7 8 9 10 11

Sin comentarios

Multitech MT56DSU-R Manual de usuario Pagina 8