
--......
... U" 1 <1UVI """"p/ ""vn..""" lUU"" Ua.V';; a. Ulllj\,;l Ijl11.ry lur Ullj LLYpurl; -~
Direct ttyxxx -yyyy direct where yyyy is baud rate
File /dev/rtyxxx must have permissions:
chmod 777 /dev/ttyxxx
If a lock file exits for this tty, remove it from /usr/spool/uucp
Command is cu -Ittyxxx
A CONNECTED message should be received. At this point, if cabling and modem set
properly, communication with modem can take place.
To disconnect type -. enter
Useful modem commands:
AT&F.- set factory defaults
AT&WO- Store modem settings in non volatile memory
ATDTx- Dial phone number x
ATL5- Display some modem settings -/-I4feh IltAld.e~~ lJ~
ATL- Display phone number storage
AT$SBxxxx Set serial port baud rate
AT$MBxxxx Set modem baud rate
AT$D1- Set DTR dialing
ATNx-Dial phone number stored at position x
/}-r~O- c/tblV>J4'-~
soME' OTHER MODEM SETUPS:
696E Modem, Dialup, With Terminal and Local Printer.
Factory default, ATE1&E5&E7&E8&EI0&E13&EI4$BAI
* Dial In-to Modem, Connected To Computer, That Will Not Disconnect When Exiting From Unix
(Control D or Exit) use following command:
AT&DOwhich causes modem to ignore DTR from computer.
Modify or silence results codes. Useful to eliminate many login messages and bad login userid's when
modem answers a calL Be careful with these. If ATQl is used, there will be no response from modem after
it receives a command.
ATVO- Result code sent as digits (terse).
ATQI-Result codes suppressed (quiet).
Multitech 224 modem
At&F - Load factory defaults
AT&El- Set Auto-Reliable Mode
AT&WO- Store
Set all switches up except 1,3,8 down.
If used with St. E Link set all swicthes up except 1,3,6,8 down
.....
ZDX Modem for ECS on Altos 500 or 1000 systems
- AT&F- Factory default
AT$SBxxxx- Serial Baud Rate
AT&CO- Force on Carrier Detect and Data Set Ready
- ,
AT&WO- Store
Comentarios a estos manuales