Multitech MTCMR-H Guía de usuario Pagina 43

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 147
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 42
Chapter 3 – Supported GSM/WCDMA AT Commands
High Speed HSPA-H4 AT Commands Reference Guide (Document S000483A) 43
Chapter 3 – Supported
GSM/WCDMA 3G AT Commands
Supported ITU-T Recommendation V.250 Commands
&D Set DTR Function Mode
Description: This command controls the Data Terminal Ready (DTR) function mode.
Syntax:
Command Responses
Action Command:
AT&D[<n>]
OK
No Read and Test Commands
Values: <n> DTR Signal Control Parameter
0 The DTR signal is ignored
1 Modem switches from data to command mode when DTR switches from ON to
OFF
2 Upon DTR switch from ON to OFF, the call is released. Default.
Parameter Storage: The <n> parameter is stored in EEPROM using AT&W. The default value can be
restored using AT&F.
Examples:
Command Responses
AT&D0
Note: The DTR signal is ignored
OK
Note: Command valid
AT&D1
Note: Modem switches from data to
command mode when DTR switches from
ON to OFF
OK
Note: Command valid
AT&D2
Note: Upon DTR switch from ON to OFF,
the call is released
OK
Note: Command valid
Vista de pagina 42
1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 146 147

Comentarios a estos manuales

Sin comentarios