Multitech MA6 Especificaciones descargar pdf (Pagina 30)

30 MA6

5 Disconnect the power and data cables from the back of the floppy disk drive.

6 Remove the four screws securing the floppy drive to the drive chassis.

7 Open the front door, remove floppy drive by sliding it out the front of the drive

chassis.

8 To install a new floppy drive, follow steps 1-7 in reverse.

Note

Before installing card cage, make sure power connectors from

power supply to midplane are fully connected.

CDROM Removal/Replacement

Table 4.6 CD ROM Removal/Replacement Procedure

Step Procedure

1 Remove the MiniArray

III

from rack enclosure following the steps in Table 4.1.

2 Remove the top cover from the MiniArray

III

by removing the seven cover mounting

screws located in the back of the MiniArray

III

. See figure 4-3.

3 Remove the chassis mounting screw from the card cage. See figure 4-4.

4 Being careful to maintain slack in the power cables, lift the card cage, including fan

housing, up and over so that it can rest along side the chassis.

5 Disconnect the power and data cables from the back of the CDROM drive.

6 Remove the four screws securing the CDROM drive to the drive chassis.

7 Open the front door and remove CDROM drive by sliding it out the front of the drive

chassis.

8 To install a new CDROM drive, follow steps 1-7 in reverse.

Note

Before installing card cage, make sure power connectors

from power supply to midplane are fully connected.

Power Supply Removal/Replacement

The card cage has to be removed in order to disconnect the power wiring before the power

supply can be removed.

Table 4.7 Power Supply Removal/Replacement Procedure

Step Procedure

1 Remove the MiniArray

III

from rack enclosure following the steps in Table 4.1.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 67 68

Sin comentarios

Multitech MA6 Especificaciones Pagina 30