Multitech MTPSR2-201 Guía de usuario descargar pdf (Pagina 7)

V.35 Shunt Procedure

If you are using an external DCE device on the WAN 2 RS232/

V.35 port, and the connection will be a V.35 connection, the the

interal shunt must be moved from the RS232C (default)

position prior to cabling and power-up. The following steps

detail the procedures for switching the shunt.

Step Procedure

1 Ensure that the external power supply is disconnected

from the ProxyServer.

2 Turn the ProxyServer over and remove the cabinet

mounting screw from the chassis.

Front Panel

Back Panel

Cabinet Mounting Screw

Figure 2-2. Cabinet Mounting Screw

3 Being sure to support the back panel, turn the

ProxyServer right-side-up, tilt the back panel down, and

slide the circuit board out of the chassis.

1 2 3 4 5 6 7 8 9 10 11 12 ... 17 18

Sin comentarios

Multitech MTPSR2-201 Guía de usuario Pagina 7