Multitech MULTIVOIP MVP-810 Guía de usuario descargar pdf (Pagina 18)

Chapter 2 – Installing and Cabling the MultiVOIP

18 MultiVOIP® Voice/Fax over IP Gateways

3. Pull the main circuit card out about 5 inches (the power connection to the board prevents it from being

removed entirely from the chassis).

4. Identify the channels on which the DID interface is used.

5. Position the jumper for each DID channel so that it does not connect the two jumper posts. For DID

operation of a VOIP channel, the MultiVOIP works properly if you simply remove the jumper altogether, but

that is inadvisable because the jumper might be needed later if a different telephony interface is used for

that VOIP channel.

6. Slide the main circuit card back into the MultiVOIP chassis and replace the three screws.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 162 163

Sin comentarios

Multitech MULTIVOIP MVP-810 Guía de usuario Pagina 18