Multitech MULTIVOIP MVP-810 Guía de usuario descargar pdf (Pagina 44)

Chapter 4 – Configuring Your MultiVOIP

44 MultiVOIP® Voice/Fax over IP Gateways

Configuring FXS Loop Start Parameters

The figure and table that follow describe the parameters applicable to FXS Loop Start.

FXS Loop Start Interface: Parameter Definitions

Field Name

Values

Description

Dialing Options fields

FXS (Loop Start)

Y/N

Enables FXS Loop Start interface type.

Inter Digit Timer

1 - 10 seconds

This is the length of time that the MultiVOIP waits between digits. When the

time expires, the MultiVOIP looks in the outbound phonebook for the number

entered and place the call accordingly.

Default = 2.

Message Waiting Indication

Not applicable to –SS series MultiVOIPs.

Inter Digit Regeneration

Time

in milliseconds

The length of time between the outputting of DTMF digits.

Default = 100 ms.

FXS Options fields

FXS Ring Count, FXS

1-10

Maximum number of rings that the MultiVOIP issues before giving up the

attempted call.

Current Loss

Y/N

When enabled, the MultiVOIP interrupts loop current in the FXS circuit to

initiate a disconnection. This tells the device connected to the FXS port to hang

up. The Multi-VOIP cannot drop the call; the FXS device must go on hook.

Generate Current Reversal

Y/N

When selected, this option implements Answer Supervision and Disconnect

Supervision to the FXO interface using current reversal to indicate events.

Applicable only when FXS and FXO interfaces are connected back to back.

Table is continued on next page…

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 162 163

Sin comentarios

Multitech MULTIVOIP MVP-810 Guía de usuario Pagina 44