Multitech PROXYSERVER MTPSR1-120 Guía de usuario descargar pdf (Pagina 9)

Chapter 1 - Introduction and Description

Back Panel Description

The cable connections for the Firewall are made at the back panel. In addition to the Power

connector, Three groups of connectors are used on the Firewall: the Command Port, Ethernet 1

& 2 (10BASET) and RS232/V.35. The cable connections are shown in Figure 1-3 and defined in

the following groups.

ETHERNET

COMMAND

10BASET

OFF

RS232/V.35

POWER

Figure 1-3. Back Panel

RS232/V.35 Connector

The RS232/V.35 (DB-25) connector is used to connect the Firewall to an external modem, DSU,

or other Data Communications Equipment (DCE). This connection can be either RS232C

(default) or V.35. If the connection is V.35, then the shunt must be moved from the default RS232

position to the V.35 position (for details on this procedure, refer to Chapter 2 - V.35 Shunt

Procedure).

Ethernet 1 and 2 10Base-T Connectors

The Ethernet 10Base-T connectors are used to connect the Firewall to a LAN using unshielded

twisted cable. Ethernet 1 connects the Secured (private) LAN, and Ethernet 2 connects the

Internet (public) LAN. These connectors are RJ-45 jacks.

Command Connector

The Command connector is used to configure the Firewall using a PC with a serial port and

running Windows® software. The Command connector is an RJ-45 jack and a short adapter

cable is provided to convert to a standard serial port DB-25 female connector.

Power Connector

The Power connector is used to connect the external power supply to the Firewall. The Power

connector is a 6-pin circular DIN connector. A separate power cord is connected to the power

supply and the live AC grounded outlet.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 79 80

Sin comentarios

Multitech PROXYSERVER MTPSR1-120 Guía de usuario Pagina 9