Multitech RF825-E-AP Guía de usuario descargar pdf (Pagina 11)

Quick Start Guide RouteFinder RF825 Series

Dial Number: For CDMA models, type #777

For EDGE models, type *99***1#.

Save: Click the Save button.

Init String 1: For EDGE models, type

AT+CGDCONT=1,"IP","<APN>"

Note: The APN (Access Point Name) is

assigned by your wireless service provider.

An access point is an IP network to which a

mobile device can be connected.

Signal Strength Command: For CDMA, enter AT+CCED.

For EDGE, enter AT+CSQ.

Save: Click the Save button.

11. Click Save & Restart (located on the Menu bar).

12. After the RouteFinder has restarted and the Status light is

flashing, wait for about 1 minute to be sure that the TR and CD

LEDs are lit and showing a solid light (not blinking).

13. From the workstation, open the command window by clicking the

Start button and selecting Run.

14. Type CMD to open the command window. Click OK.

15. When the command window opens, type IPCONFIG /RELEASE

to release your current IP received from the RouteFinder.

16. Then type IPCONFIG /RENEW to renew your IP address from

the RouteFinder. You should also receive a DNS address from

the RouteFinder.

17. Close the command window.

18. Open a Web browser. You are now connected to the Internet.

19. To verify a connection, go to the RouteFinder's software screen,

Statistics & Logs > PPP Cellular/Analog Log.

To Disable Your Cellular Connection

Uncheck the Status box for the PPP option by using the RouteFinder's

Web Management software Wizard Setup screen or select Network Setup

> PPP Cellular/Analog Backup and disable PPP.

Additional Configuration of the Cellular Modem

You may want to further communicate directly to the cellular modem for

checking signal strength, verifying network registration, and/or

troubleshooting your Internet connection. This information is available in

the User Guide.

1 2 ... 6 7 8 9 10 11 12

Sin comentarios

Multitech RF825-E-AP Guía de usuario Pagina 11