Multitech MT2834ZDX Especificaciones descargar pdf (Pagina 53)

4 AT Commands, S-Registers, and Result Codes

L10 List signal to noise ratio information (SNR).

L11 List noise information.

Note: For L9, L10, and L11, you must first type +++AT<CR> (on-line

escape command while maintaining command mode), then type the

command prefixed by an AT (e.g., ATL10).

Command: #L

V.42 Mode Selection in Originate Mode

Values:

= 0, 1, 2, or 3

Default: 0

Description: #L0 Modems negotiate V.42 mode.

#L1 MNP on & LAP-M off.

#L2 LAP-M on & MNP off.

#L3 Disable detection phase and go directly to LAP-M.

Command: M

Modem Speaker Control

Values:

= 0, 1, 2, or 3

Default: 1

Description: M0 Speaker always off.

M1 Speaker on until carrier signal detected.

M2 Speaker always on.

M3 Speaker on during dialing, off during handshaking.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 103 104

Sin comentarios

Multitech MT2834ZDX Especificaciones Pagina 53