Multitech MT5634HD16 Guía de usuario descargar pdf (Pagina 15)

2 Installation

CommPlete Communications Server 9

Pre-Installation Notes

Warning: Direct interconnection (or connection by way of other apparatus) of ports marked “SAFETY

WARNING see instructions for use” with any other ports (whether or not similarly marked) may

produce hazardous conditions on the network.

MultiTech strongly urges you to consult a qualified engineer before attempting to make this type of

connection.

• All installation must be done by a qualified service person.

• To reduce emissions, be sure to use blanking plates to cover empty slots in the CC9600 chassis.

• Cable, wiring, and any other apparatus connected between the MT5634HD8/16K modem and the point

of connection to any speech band circuit shall comply with the following:

1. The overall characteristics of the apparatus shall be such as to introduce no material effect upon

the electrical conditions presented to one another by the modem and the speech band circuit.

2. The apparatus shall comprise only

a. apparatus approved for the purpose of connection between the modem and a speech band

circuit; and

b. cable and wiring complying with a code of practice for the installation of equipment

covered by this part of BS 6328 or such other requirements as may be applicable.

Note: Such apparatus may have been approved subject to limitations in its use.

Installation Procedure

1. Unpack the MT5634HD8/16 assembly from its factory packaging. (You may wish to save the

packaging for possible future use.)

2. Perform a visual inspection of the MT5634HD8/16. If you are concerned about its condition, call

Technical Support for instructions.

3. The MT5634HD8/16 must be installed in a segment in which a RASCard is installed. Turn off the

RAS segment where the MT5634HD8/16 will be installed. (Turn off power to this segment.)

4. Remove a blank device front panel or previous MT5634HD8/16 card from the RAS segment used in

step 3. Do

not

remove the back panel.

5. Support the MT5634HD8/16 by the front panel and the bottom edge of the card, and carefully place

it into the CC9600’s open device slot. Make sure the edges of the MT5634HD8/16 card mate properly

with the guides of the device slot.

6. Slide the MT5634HD8/16 into the CC9600 chassis until you feel the MT5634HD16’s connectors mate

with the CC9600’s bus connectors.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 83 84

Sin comentarios

Multitech MT5634HD16 Guía de usuario Pagina 15