Multitech MT5634HD16 Guía de usuario descargar pdf (Pagina 21)

3 AT Commands

CommPlete Communications Server 15

Topic Command Description Page

Immediate Action A/ Repeat last command 27

I Information request

&B V.32 auto retrain

&V View current configuration

Flow Control &M0 Asynchronous mode 27

&K0 or \Q0 Flow control disabled

&K3 or \Q3 Hardware flow control

&K4 or \Q1 XON/XOFF flow control

\X0 XON/XOFF no pass-through

&J Auxiliary relay control

\J Enable data buffer control

\G Modem port flow control

\K Set break control

+ES=6 Enable synchronous buffered mode

Escape +++AT<CR> Default in-band escape sequence 29

Sequences A Force answer mode

O Go back online

Diagnostics &T Self-test commands 31

Speaker Settings L Monitor speaker volume 31

M Monitor speaker mode

Dialing Commands

Dialing commands are used to dial and hang up.

Ds Dial

= phone number

Default: none

The letter

in a command causes the modem to dial the telephone number immediately following it. For

example, if you type

ATD5551212<CR>, the modem dials the number 555-1212.

The MT5634HD8/16 supports several dialing methods. With the D command, you can specify either pulse

(ATDP) or tone (ATDT) dialing. You can also modify the dialing command with several other characters

that are explained in the section “Dial Modifier Commands”, later in this chapter.

The modem also lets you select either smart (wait-for-dial-tone) dialing or blind dialing. With smart

dialing, the modem waits for and detects dial tones and busy signals. With blind dialing, the modem works

with timed pauses (determined by the value of register S6), not dial tone and busy signal detection. See the

X command for more information on blind and smart dialing.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 83 84

Sin comentarios

Multitech MT5634HD16 Guía de usuario Pagina 21