Multitech MTCMR-E1 Guía de usuario descargar pdf (Pagina 6)

MultiModem rCell Intelligent Wireless Router

6 Multi-Tech Systems, Inc. Quick Start Guide

2. Using an Ethernet cable, connect one end of the cable to the

ETHERNET connector on the back of the router and the other end to

your PC either directly or via a switch or hub.

3. If you are connecting a customer’s legacy device to the router,

connect the serial, RS232 cable from the customer’s device to the

RS232 connector on the back of the router.

4. Depending on the power source, connect either the power supply

module with the appropriate blade or the optional DC power cable.

If you are using the power supply module, remove the protective

shipping cover. Attach the appropriate interchangeable blade piece

to the power supply module.

5. Screw-on the power lead from the power supply module into the

power connection on the router. Now, plug the power supply into

your power source.

For Optional Direct DC Power

● Screw-on the DC power cable into the power connector on the router.

● Then attach the two wires at the other end of the DC power cable to a

DC fuse/terminal block in which you are mounting the MultiRouter.

● Connect the red wire to the "+" (positive) terminal and the black wire to

the "–" (negative) terminal. Be sure the GND connection is correct.

Warning: Over-voltage protection is provided on the device. To ensure

complete protection, you may want to add additional filtering to the DC

input.

Note: For an application involving a battery, you can use permanent “+”

or key-switched “+” source. Connect the power supply to its source

(for example, in a mobile situation, to the vehicle’s DC fuse/terminal

block).

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Sin comentarios

Multitech MTCMR-E1 Guía de usuario Pagina 6