
10
MultiFRAD 100-Series User Guide
FR111A
Shunts
There are two shunt positions in the middle/right side of the printed circuit board that configure the
data port for either an RS-232 or V.35 interface. The shunts are shown in Figure 1-4.
LEDs
RS-232C Trunk Shunt Position
V.35 Trunk Shunt Position
Figure 1-4. Shunts
The data port shunts are shown in the RS-232 (default) position in Figure 1-4. To change the
position of a shunt, refer to the V.35 Shunt procedure in Chapter 2.
Comentarios a estos manuales