Multitech MT2834ZPX Guía de usuario descargar pdf (Pagina 11)

Command Function/Options

&Wn Save Modem Parameters.

&W0 Instructs modem to save current parameters in nonvolatile RAM. The

modem will load these parameters for future sessions instead of reading

factory ROM defaults (unless the &F command is issued).

* &W1 Instructs modem to not save parameters to RAM.

Xn Extended Result Codes.

* X0 Basic Result Codes (CONNECT).

X1 Extended Result Codes (CONNECT 9600).

X2 Extended Result Codes, Enable Dialtone Detect.

X3 Extended Result Codes, Enable Busy Detect.

X4 Extended Result Codes, Enable Dialtone Detect and Busy Detect.

#Xn XON / XOFF Configuration.

* #X0 Single XOFF character sent until XON level returns.

#X1 Multiple XOFF characters sent after buffer level is full.

Yn Enable/Disable Long Space Disconnect.

* Y0 Disable Long Space Disconnect.

Y1 Enable Long Space Disconnect.

Z Reset Modem. All configuration parameters are reset to default values.

, (Comma) Pause. Creates pause during dialing. The duration of the pause is determined

by Register S6.

/ (Slash) Pause for 125 MS.

: (Colon) Continuous Redial.

; (Semicolon) Return to Command Mode after dialing.

! (Exclamation) Causes modem to flash on-hook.

@ Quiet Mode. Causes modem to wait for ringback, followed by five seconds of silence

before processing next command.

+++AT In-band Escape Sequence. Places modem in Command Mode, while still remaining

on-line. Type +++ followed by the letters "AT", and then enter up to ten

command characters.

BREAK AT Out-of-Band Escape Sequence. Places modem in Command Mode while still

remaining on-line. Not preceded by AT. Enter a BREAK signal, followed by the

letters "AT", and then enter up to sixty command characters.

3-7

SRM-100 - AT Command Reference Guide; Multi-Tech Format AT Command Set

1 2 ... 6 7 8 9 10 11 12 13 14 15

Sin comentarios

Multitech MT2834ZPX Guía de usuario Pagina 11