Multitech MT2834ZPX Guía de usuario descargar pdf (Pagina 13)

S11 1 - 255 70 Tone Dialing; Tone Spacing and Duration. Sets the duration and spacing (in

milliseconds) between DTMF (touch tone) dialing characters.

S12 to S16 --- --- Not Used.

S17 0 - 250 250 Change Break Time. Defines the break time (space) (in 10 Ms increments) to local

PC.

S18 to S23 --- --- Not Used.

S24 0 - 255 20 PBX/CBX Disconnect Drop Time for DSR/CTS/DCD. Defines the DSR/CTS/DCD

drop out time in 50 mSec increments. The default value of "20 equals one second.

S25 0 - 255 0 DTR Dropout Time. Defines DTR dropout time in 100 mSec increments. The default

value of "0" equals 50 Msec.

S26 0 - 255 0 Failed Password Attempts. Counts the number of failed password attempts.

S27 to S28 --- --- Not Used.

S29 1 - 255 20 Local Inactivity Timer. Defines the amount of idle time (in minutes) that can elapse

between AT commands after the SETUP password has been entered.

S30 0 - 255 0 Inactivity Timer. Sets the length of time (in minutes) that the modem will stay on-line

before disconnecting when no data is

sent or received.

S31 --- --- Not Used.

S32 0 - 255 20 Time Elapse for Escape Sequence. Determines the period of time (in seconds) that the

modem will wait for a <CR> to be entered during escape sequence execution.

S33 --- --- Not Used.

S34 0 - 60 10 Buffer Length of Command Mode (After On-line Escape Sequence). Sets the buffer

length (in ASCII characters) of the command mode after on-line escape sequence.

S35 --- --- Not Used.

S36 0 - 255 0 Time Between DTR Inactive and Modem Off- Hook. Sets the time (in seconds)

between DTR inactive (low) and the modem going off-hook. When Register S36=0,

the DTR Busy-out feature is disabled.

S37 0 - 255 5 Time Between DTR Active and Modem On-Hook. Sets the time (in seconds) that will

elapse between the DTR signal becoming active and the modem going on-hook (not

busy).

S38 to S47 --- --- Not Used

S48 33, 31, 28,

26, 21, 19,

16, 14, 12,

9,4or0

0 Program V.34 Connect Speeds. Defines which speed modem connects within V.34

mode scope (e.g., S48=21 means maximum connect speed is 21.6K). This register

compensates for line conditions that will not support higher V.34 speeds (e.g., 33.6K,

31.2K, 28K, 26.4K, 24K, and etc.). The default value of 0 specifies a connection

attempt at 33.6K.

4-2

SRM-100 - AT Command Reference Guide; Multi-Tech Format S-Registers

1 2 ... 8 9 10 11 12 13 14 15

Sin comentarios

Multitech MT2834ZPX Guía de usuario Pagina 13