Multitech MTC-C2 Guía de usuario descargar pdf (Pagina 25)

CONFIGURING AND COMMUNICATING WITH YOUR DEVICE

AT+CSQ

2. Verify device is registered on the cellular network.

Enter:

AT!STATUS

3. Configure socket parameters

Enter:

AT#SCFG=1,1,300,240,600,50

4. Activate context one

Enter:

AT#SGACT=1,1

5. Set firewall rule to accept connections:

AT#FRWL=1,"###.##.###.#","###.##.###.#" where ###.##.###.# represents the IP range. For example:

AT#FRWL=1,"204.26.122.1","204.26.122.255"

6. Set connection ID 1 for UDP listening mode on port 7000.

Enter:

AT#SLUDP=1,1,7000

The device responds with and unsolicited indication that a host is trying to connect to connection ID 1 on

port 7000.

SRING: 1

7. Accept incoming connection ID 1

Enter:

AT#SA=1

The device indicates a client successfully established a listener connection.

CONNECT

You can send and receive data.

Exit Data Mode and Close Connection

To exit data mode and close the socket:

■ Enter the escape sequence: +++

■ To close Socket 1, enter: AT#SH=1

The device responds with OK.

■ To close the data connection, enter:AT#SGACT=1,0

The device responds with OK.

Configuring Device as UDP Client to Connect to UDP Server

Configure and Connect the Device

To configure the device as a UDP client:

1. Check signal strength.

Enter:

AT+CSQ

MultiConnect

Cell User Guide 25

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 33 34

Sin comentarios

Multitech MTC-C2 Guía de usuario Pagina 25