Multitech MTS2WFA-R Manual de usuario descargar pdf (Pagina 13)

Chapter 3 – WLAN Commands

Multi-Tech Systems, Inc. AT Commands for the MT800SWM & MTS2WFA (S000425D) 13

#WLANGETRSSI – Received Signal Strength

Description: This command displays the current received signal strength.

Syntax: Set Value: AT#WLANGETRSSI

Values: NA

#WEP? – See the Value of WEP Keys

Description: This command displays the values of the WEP keys.

Syntax: Set Value: AT#WEP?

Values: WEP64KEY1:6162636465

WEP64KEY2:6162636465

WEP64KEY3:6162636465

WEP64KEY4:6162636465

WEP128KEY1:12345678901234567890123456

WEP128KEY2:12345678901234567890123456

WEP128KEY3:12345678901234567890123456

WEP128KEY4:12345678901234567890123456

#WLANPOWERSAVE – Enable Power Save at Boot

Description: This command sets the Power Save at the Boot Works after the Power Cycle.

Syntax: Set Value: AT#WLANPOWERSAVE=<value>

Values: 0 Power Save Disabled

1 Power Save Enabled

Default: 0

#WLANDOZE – Move Module into Power Save

Description: This command moves the module into Power Save during an active connection.

Syntax: Set Value: AT#WLANDOZE

Values: NA

#WLANACTIVATE – Move Module out Power Save

Description: This command moves the module out of Power Save during an active connection.

Syntax: Set Value: AT#WLANACTIVATE

Values: NA

#WLANROAM – Enable/Disable Roaming

Description: This command enables/disables automatic roaming of the module when the wireless

connection is lost by the Access Point.

Syntax: Set Value: AT#WLANROAM

Values: 0 Disable Auto Roam

1 Enable Auto Roam

Default: 1

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 37 38

Sin comentarios

Multitech MTS2WFA-R Manual de usuario Pagina 13