Multitech MTS2WFA-R Manual de usuario descargar pdf (Pagina 28)

Chapter 7 – FTP Commands

Multi-Tech Systems, Inc. AT Commands for the MT800SWM & MTS2WFA (S000425D) 28

Chapter 7 – FTP Commands

#FTPPORT – Port of the FTP Server

Description: To reach the FTP server, the TCP/IP stack software must know the control port of the

FTP server used for file transfer.

Note: This parameter should be changed only upon request of your network

administrator since it applies to network infrastructure including firewalls, proxy or specific

TCP port translation.

Syntax: Set Value: AT#FTPPORT=<value>

View Value: AT#FTPPORT?

Values: A number between 0 and 65535. A value of zero is not allowed.

Default Value: 21

#FTPMODE – FTP Mode

Description: Define the FTP behavior for file transfer.

Syntax: Set Value: AT#FTPMODE=<value>

View Value: AT#FTPMODE?

Values: 0 FTP Active Mode

1 FTP Passive Mode

Default Value: 0 FTP Active Mode

#FTPTYPE – Type of FTP Session

Description: Before transferring files from a specified FTP server, the TCP/IP stack software must

specify the type of data to be transferred within the FTP session.

Syntax: Set Value: AT#FTPTYPE=<value>

View Value: AT#FTPTYPE?

Values: 0 ASCII sessions

1 Binary sessions (upper case i letter)

Default Value: 0 ASCII sessions

#FTPSERV – FTP Server Address

Description: To connect to an FTP server to download files, the TCP/IP stack software must know the

address of the FTP server that is to be used.

Syntax: Set Value: AT#FTPSERV=<value>

View Value: AT#FTPSERV?

Values: 32-bit number in dotted-decimal notation (i.e., xxx.xxx.xxx.xxx) or alphanumeric ASCII

text string up to 120 characters if DNS is available. It will take a blank space also.

Default Value: None

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 37 38

Sin comentarios

Multitech MTS2WFA-R Manual de usuario Pagina 28