Multitech ISI608PC El manual del propietario descargar pdf (Pagina 15)

2 - Hardware Installation

Table 2-2 (cont’d)

Step Procedure

4a The default setting for the ISI608’s base I/O address is

200 hex. The default value for the IRQ jumper is IRQ

3. Choose the IRQ value by covering the appropriate

pins with the shorting plug (supplied). Reference the

diagram shown below, if needed. If your system

requires a different setting or if you are installing

multiple cards, refer to Appendix B for a table of valid

address settings.

200 hex/IRQ 3

Figure 2-2. I/O Address/IRQ Default Setting

Note: If you are installing the ISI608 as a second card in a

MultiComRN

Gateway

(remote node gateway) the suggested

I/O address is 210 hex/IRQ4.

210 hex/IRQ 4

Figure 2-3. I/O Address /IRQ Alternate Setting

Record any changes you make to these settings and keep

them handy for the software installation section in

Chapter 3.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 80 81

Sin comentarios

Multitech ISI608PC El manual del propietario Pagina 15