Multitech ISI608PC El manual del propietario descargar pdf (Pagina 34)

ISI608PC Owner’s Manual

Removing the Driver (SCO XENIX)

If you find it necessary to remove the Multi-Tech Serial Card

Driver, you should enter the configuration utility SCO XENIX

(Custom) and follow the instructions to remove the entire

driver and to rebuild the kernel without the ISI driver. You must

also remove the "d608" file: rm /etc/perms/d608. If it is

necessary to re-install the driver, due to I/O address or IRQ

overlap, you must remove the driver first.

Installing the ISI608 Driver on a UNIXWare

Computer

The installation utility provided in UNIXWare is called

pkgadd

To install the ISI608 driver, you must run pkgadd and follow

the instructions below.

Table 3-7: ISI608 Driver Installation for UnixWare

Step Procedure

1 If you are installing the driver from floppy disk drive 1,

type pkgadd -d diskette1 and press <Enter>. If

floppy disk drive 2 is being used, type pkgadd -d

diskette2 and press <Enter>.

2 The following message is displayed:

Insert diskette into Floppy Drive 1

Type [go] when ready,

or [q] to quit: (default: go)

3 Insert a copy of Multi-Tech’s ISI608 Driver diskette

into the selected floppy disk drive.

4 Type “go” or press <Enter> to start the installation of

the driver.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 80 81

Sin comentarios

Multitech ISI608PC El manual del propietario Pagina 34