Multitech ISI608PC El manual del propietario descargar pdf (Pagina 30)

ISI608PC Owner’s Manual

Removing the Driver (SCO UNIX)

If you find it necessary to remove the Multi-Tech Serial Card

Driver, you should enter the configuration utility (i.e., custom

for SCO UNIX) and follow the instructions to remove the entire

driver and to rebuild the kernel without the ISI driver. If it is

necessary to re-install the driver, due to I/O address or IRQ

overlap, you must remove the driver first.

Installation in SCO XENIX

The installation utility provided in SCO XENIX is called

custom

. This section is a brief guideline for invoking the utility

and installing the driver. The instructions contained in the

following table should only be used on SCO XENIX systems.

When you have completed the steps in Table 3-5, you will be

directed to Section 3.9 for a discussion of the Multi-Tech

Installation Script.

Table 3-5

ISI608 Driver Installation for SCO XENIX

Step Procedure

1 If you are installing the driver from your default floppy

drive, type custom and press "Enter" to call up the

custom

utility. If you are using a non-default drive, you

must inform your system of the disk drive from which

you will be doing the installation and the size and

capacity of the diskette(s). The following chart

provides the two command options for

custom

. Insert

a copy of the Multi-Tech driver diskette volume 1, and

input the appropriate command.

Disk Drive Designation

DRIVE DISK DISK

SPEC SIZE CAPAC

.ENTER THIS COMMAND

0 3.5" 720K custom -m /dev/rfd0135ds9 press "Enter"

1 3.5" 720K custom -m /dev/rfd1135ds9 press "Enter"

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 80 81

Sin comentarios

Multitech ISI608PC El manual del propietario Pagina 30