Multitech RF560VPN Manual de usuario descargar pdf (Pagina 48)

Multi-Tech Systems, Inc.

RF550VPN/RF560VPN Reference Guide – Setup Examples 48

2. Click the button on the left side of the screen for VPN Settings. Use this screen to enter the LAN-to-

Client VPN connection name: In the Connection Name field, type a name that identifies for you a

connection that you would like to make. (Ex: StaticSentinel). Click the Add button.

The VPN Settings screen for entering specific VPN settings will display. The Connection Name

(StaticSentinel) defaults into the first field. The issue of dynamic versus static IP at the client is

addressed in the steps listed under this screen shot. Continue to enter the following settings:

a) Select Disable UID and leave Local IPSec Identifier and Remote IPSec Identifier blank.

b) Disable (do not check) Keep Alive.

c) Disable (do not check) NetBIOS Broadcast.

d) Remote Site = LAN

e) Remote IP Network – Enter the Remote IP Network address. Since there is no remote

LAN, enter the static IP 204.26.122.50 of the SSH client. If Sentinel client is using a

dynamic IP, enter 0.0.0.0.

f) Remote IP Netmask – Enter the Remote IP Netmask address. Since there is no remote

LAN, enter 255.255.255.255 for a static IP. If Sentinel client is using a dynamic IP, enter

0.0.0.0.

g) Remote Gateway IP – Enter the Remote Gateway IP address (WAN) for the Sentinel client.

If the client is using a static IP, enter the IP address. (Ex: 204.26.122.50) If the Sentinel client

is using a dynamic IP, enter 0.0.0.0.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 58 59

Sin comentarios

Multitech RF560VPN Manual de usuario Pagina 48