Multitech BL-Series Manual de usuario descargar pdf (Pagina 22)

Chapter 3.

Slot - 12 15

Connector - B B

TAB NO. RETAINED : For Module 3 - 4 4

CABLE MARKER : - RRSA RRSB

ASSEMBLY PROCEDURE : Soldering Iron (For jumper wire)

Ref . Tables 3-1 and 3-2, 3-3 and Fig.

3.2 (b)

For ACIO connection details refer

Table No. 3-3.

* These parts are to be connected as shown in Fig.3.2(c)

Notes:

1. Wire wrap the pairs onto contact block pins of each module as per

wiring details given.

2. Snap the hood onto the contact block such that polarity tab(1) is

towards pin 1 as per wiring done.

3. The shields of the four digital trunk cables are joined together at MDF

end. Solder 32/0.2 square mm multistrand wire on to the shield (copper

braid) at the point shown and crimping terminal ring as shown.

4. The wire length shall be as shown in the figure.

5. Polarity tabs to be retained as given below module 1:2, module 2:3,

module 3:4.

6. Put 6.00mm black silicon rubber sleeve for L1.

7. Put 12.0mm PVC/Black silicon rubber sleeve of 50mm length at both

ends of L tied with cable ties.

8. The four digital trunk cables on each side (copy 0 and copy 1) are tied

together with cable ties.

Note :

All signal names are w.r.t RBM side.

20 C-DOT DSS MAX-XL

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 59 60

Sin comentarios

Multitech BL-Series Manual de usuario Pagina 22