Multitech BL-Series Manual de usuario descargar pdf (Pagina 8)

Chapter 1.

1. Only an even numbered BM can be made as an RSU

RSU Side :

(BM-L/BM-XL)

- To distinguish between a Remote Base Module and

colocated Base Module, the Most Significant Bit (MSB)

position on each column of jumper settings on copy 0 and

copy 1 side of Base Processor Unit (BPU) mother board is

made one, i.e. it is left open.

- Time Switch Switch (TSS) card will be replaced by

Enhanced Remote Time Switch (ETS) card.

- For connection with the parent exchange, two sets of

digital trunk cables for Bus-0 and Bus-1 from the Time

Switch Unit (TSU) of RBM will be laid towards the

DDF/MDF.

CM Side

- On the CM side, Space Switch Multiplexer card in Bus

Termination unit will be replaced by Enhanced Remote

Space Switch Multiplexer in the slot where a RSU link is

to be connected as given below.

CM-L : SSM replaced by ESL

CM-XL : PSM replaced by ESM

- Two sets of digital trunk cables coming from the RSU (i.e.

from DDF of CM side) as Bus-0 and Bus-1 will be

terminated on to corresponding bus of ESL/ESM card in

BTU. The other position in the same ESL/ESM card will

be used for connecting a colocated BM.

Note:

Each SSM/PSM supports two local BMs

Each ESL/ESM supports one local BM and one RBM.

6 C-DOT DSS MAX-XL

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 59 60

Sin comentarios

Multitech BL-Series Manual de usuario Pagina 8