Multitech BL-Series Manual de usuario descargar pdf (Pagina 48)

Chapter 4.

4. Set serial baud rate and modem baud rate to 9600 bps

5. Disable DTR signal

Note :

1. For configuring modem using AT commands; power on modem, connect

terminal to modem, issue AT commands to achieve required

configuration. For exact commands, refer modem user guide/operation

manual.

2. Use jumper settings if any, to achieve above configuration

3. Typical AT commands for configuring multi-tech MT2834ZDX are

given in section 4.4.3, 4.4.4 for reference.

4.4.3. Procedure for Configuring Multitech (MT2834ZDX) for Dial Up

Working

For dial up working the following are the commands for configuring modem.

AT&F8&W0↵

AT$SB9600&W0↵

AT$MB9600&W0↵

AT&E3&W0↵

AT&D0&W0↵

ATS0=1&W0↵

Jumper settings lease/dial may be set to dial position modem. Set up may be

made as shown in Fig. 4.1.

4.4.4. Procedure for Configuring Multitech (MT2834ZDX) for Leased Line

Working

Step 1:

Configure one modem as originate modem as follows :

Connect terminal to modem, set terminal speed to 9600, power on modem. On

typing 'AT', the modem responds as saying "OK".

AT&F8&W0↵ (Store default settings and save)

AT$SB9600&W0↵ (Serial baud rate set to 9600 and save)

AT$MB9600&W0↵ (Modem baud rate set to 9600 and save)

AT&E3&W0↵ (Disable flow control and save)

46 C-DOT DSS MAX-XL

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 59 60

Sin comentarios

Multitech BL-Series Manual de usuario Pagina 48