Multitech CDMA Guía de usuario descargar pdf (Pagina 18)

Chapter 3 – ! Prefix Commands

CDMA 1xEV-D0 AT Commands Reference Guide (Document S000482B) 18

Chapter 3 – ! Prefix Commands

Result codes are not shown in the following commands unless special conditions apply. Generally, the result

code OK is returned when the command has been executed. ERROR may be returned if parameters are out of

range and is returned if the command is not recognized or is not permitted in the current state or condition of the

modem. A full list of result codes (verbose and numeric) is provided in the Result Code Table later in this manual.

!APPSUBTYPES Negotiated Subtypes

Syntax: AT!APPSUBTYPES

Description: Application subtypes negotiated for the four streams.

Example: AT!APPSUBTYPES

Stream0: Default Signaling Application

Stream1: Default Packet Application for SN

Stream2: Default Packet Application for AN

Stream3: Default Test Application

!CNTSMS Count SMS

Syntax: AT!CNTSMS

Description: Reports the number of messages stored in the modem as follows:

New Urgent Msg {Index = 1}: <n>

New Regular Msg {Index = 2}: <r>

Old Messages {Index = 3}: <o>

Voice Messages {Index = 4}: <v>

The Index number corresponds to the SMS list index used to retrieve and delete

messages. The counters n, r, o, and v indicate the number of messages in each list.

When retrieving (!GSMS) or deleting (!DSMS), the message number is base 1, so the

highest message number in any list is the same as the reported count.

!DASMS Delete All SMS

Syntax: AT!DASMS

Description: Deletes all SMS messages from all four SMS lists. Use this command with care, as

confirmation is not required.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 66 67

Sin comentarios

Multitech CDMA Guía de usuario Pagina 18