Multitech CDMA Guía de usuario descargar pdf (Pagina 58)

Chapter 15 – Result Codes

CDMA 1xEV-D0 AT Commands Reference Guide (Document S000482B) 58

Chapter 15 – Result Codes

This table provides a numerical list of the standard result codes possible.

Basic Result Codes

Code Verbose Meaning

OK Command executed without errors

CONNECT Connected at any of the supported speeds

RING Alerting Signal (Ring) signal received from the network

NO CARRIER Carrier signal lost or not detected. Unable to activate the service.

ERROR Command not recognized or could not be executed. Illegal command.

Error in command line.

Command line exceeds buffer size. Parameters out of range.

NO DIAL TONE Dial tone not detected within timeout and subsequent commands not

processed

BUSY Reorder (Busy) signal detected and subsequent commands not

processed

NO ANSWER Five seconds of silence not detected after ring back when “@” (quiet

answer) dial modifier is used

Extended Cellular Result Codes

This table provides a numerical list of extended result codes that may be supported by the IWF. Note that IWF

systems may not support some or all of these codes.

Code Verbose Meaning

RING ASYNC Indicates an incoming CSC call

RING FAX (Fax Not Supported) Indicates an incoming CSC Fax call

RING PACKET Indicates an incoming packet data mode call

NO SERVICE Origination was attempted while the modem was not able to

acquire a CDMA Paging Channel

NO ASYNC SERVICE The base station rejected the async service option request

NO FAX SERVICE The base station rejected the fax service option request

BAD REQUEST An intercept was received after call origination

PAGED The modem attempted to originate a call after receiving a page

RETRY Reorder received after call origination

PAGE FAIL The modem received a page but not an alert

LINK FAIL The modem has lost the Traffic Channel

RELEASE The call has been released

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 66 67

Sin comentarios

Multitech CDMA Guía de usuario Pagina 58