
Chapter 3 – ! Prefix Commands
CDMA 1xEV-D0 AT Commands Reference Guide (Document S000482B) 24
!SLEEPPARMS Sleep Parameters
Syntax: AT!SLEEPPARMS
Description: Returns 1xEV-DO Rev. A sleep parameters (slot cycle indexes and sleep periods). Slot
cycle timeouts are listed in Julian time format (year month day day-of-week
hour:minutes:seconds).
Example 1:
at!sleepparms
Slot Cycle1:3
Slot Cycle2:0
Slot Cycle3:0
Slot Cycle1 Timeout:1980 01 06 6 00:00:00
Slot Cycle2 Timeout:1980 01 06 6 00:00:00
OK
Example 2:
at!sleepparms
HDR Rev. A not currently available
OK
!SSMS= Send SMS
Syntax: AT!SSMS=<p>,<dest>,[cb],”<text>”
AT!SSMS? Reports the progress of the last message sent
Description: !SSMS= sends an SMS message using these parameters:
Parm Meaning Range
p priority 0 = normal
1 = interactive
2 = urgent
3 = emergency
(Actual priority transmitted depends on the carrier.)
dest destination # Phone number of destination, maximum of 32 characters; only
0–9, #, and * permitted.
cb callback # (this is optional) Phone number for reply, same 32 character
limit
text message body Up to 227 bytes of data (not including the compulsory quote
marks).
The text is enclosed in quotations. The quote character cannot appear in the body text.
Body text over the carrier-defined limit is truncated and sent anyway. Messages of length
228 or greater result in an ERROR.
The query form (!SSMS?) reports the progress of the last message sent.
Possible responses are:
none No SMS messages being sent.
pending Message has not left the modem (an attempt to use !SSMS= again yields
an ERROR result code.)
sent Successfully sent to the network.
failed Sending failed and should be retried.
If you send a second message after receiving the "sent" response for the first message,
subsequent queries will report the status of the second message.
Comentarios a estos manuales