Multitech CDMA Guía de usuario Pagina 31

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 67
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 30
Chapter 5 – & Prefix Commands
CDMA 1xEV-D0 AT Commands Reference Guide (Document S000482B) 31
Chapter 5 – & Prefix
Commands
&C Data Carrier Detect Control
Syntax: AT&C<value>
Description: The modem controls the RLSD output in accordance with the parameter supplied. This
command sets the DCD On or Off.
Value Setting
0 Sets DCD to remain On at all times.
1 Sets DCD to follow the physical connection. Default
2 DCD follows the state of the TCP/UDP connection.
Response: OK
Otherwise ERROR
&D Data Terminal Ready Options
Syntax: AT&D[n]>
Description: Determines what actions the modem takes in response to the Data Terminal Ready (DTR)
signal from the host (DTE). For action to be taken, DTR must be off for a period of 2–10
milliseconds.
Note: This command has no impact on the use of DTR to terminate a voice call on the
modem, nor does it affect the use of DTR to control modem shutdown.
Value Setting
0 Ignore DTR
1 Enter command state for an on-to-off DTR transition.
The modem condition (on or offline) is not affected.
(Currently not supported.)
2 Hang up and enter command state for an on-to-off DTR transition. Auto-
answer is disabled if DTR is off. Default.
&F Factory Settings Restore
Syntax: AT&F
Description: Reloads the factory-stored default configurations into active memory. For information on
factory settings, see the Stored Profile Settings Table later in this manual.
This command is functionally the same as Z (Reset). If there is an active call, the
command executes and the call is dropped.
&V View Configuration
Syntax: AT&V[n]
Description: Displays the active profile (commands and S-register contents).
Any numeric parameter is ignored.
Vista de pagina 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 66 67

Comentarios a estos manuales

Sin comentarios