Multitech MVPGK1 Guía de usuario Pagina 16
- Pagina / 87
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
16 MultiVOIP Gatekeeper User Guide
SBC Board Cabling
The SBC board is located in the Gatekeeper as shown in Figure 2-1. The SBC board cabling may involve
connection to three back panel connectors (see Figure 2-2). The back panel connectors are:
Keyboard connector
Video connector
COM 1 connector
SBC
Backplane
6-Pin Circular Jack
(To External Keyboard)
COM 1 Connector
(DB9 male)
Connect RS-232C
Serial Cable (female end)
here
15-Pin Video
Connector
(to External
Display Monitor)
120
100M
LINK
ACT
Fig. 2-2. SBC Backplane Connections
The left round connector is for a keyboard. The middle receptacle connects the video cable to a
monitor. The right connector (COM 1) on the SBCs backplane typically accommodates a mouse or
other pointing device. The SBC connector pinouts are shown and defined in Appendix A.
Note: Any cables connected to the Gatekeeper should be shielded to reduce interference.
NIC Cabling
The 10/100Mb PCI EtherNet Network Interface Card is located as shown in Figure 2-4. The NIC has a
single RJ-45 connector and three LEDs.
Network
Interface
Card
120
RJ-45 UTP
Connector
100M
LINK
ACT
100M
LINK
ACT
Fig. 2-4. NIC Board Connectors
Connect the appropriate network cable to the NIC in the Gatekeeper. The RJ-45 NIC connector is shown
and defined in Appendix A.
Note: Any cables connected to the Gatekeeper should be shielded to reduce interference.
- MultiVOIP Gatekeeper 1
- Model MVPGK1 1
- Hardware User Guide 1
- User Guide 2
- Contents 3
- 6 Troubleshooting 35 4
- Appendices 45 4
- 1 Introduction/Description 5
- System Overview 6
- Technical Specifications 7
- SBC (Single Board Computer) 8
- Display: 9
- NIC Board (EN10100 PCI Card) 10
- Chapter 1 - System Overview 11
- 2 Installation and Setup 13
- Rack Mounting 15
- Cable Connections 15
- NIC Cabling 16
- SBC Board Cabling 16
- Powering Up 17
- 3 Single Board Computer 19
- Introduction 20
- Component Locations 21
- 4 PCI NIC Board 23
- About PCI Bus 25
- Features 25
- LED Indicators 26
- 5 Hardware Removal/ 27
- Replacement 27
- Card Cage Removal/Replacement 29
- GateKeeper 30
- Board Removal and Replacement 31
- Removing NIC Board 32
- 6 Troubleshooting 35
- Hardware Troubleshooting 36
- Chapter 6 - Troubleshooting 37
- Diagnostic Tests 38
- Calling Technical Support 39
- 7 Service, Warranty, and 40
- Technical Support 40
- Limited Warranty 41
- Ordering Accessories 42
- Tech Support 43
- About the Internet 43
- Appendices 44
- Pin Identification 45
- 6-Pin Circular Jack 46
- SBC Onboard Connectors 48
- Printer Port Connector 49
- COM 2 Port Connector 50
- Hard Disk Connector 50
- COM2 Connector 51
- External Keyboard Connector 51
- Reset Connector 51
- Floppy Disk Drive Connector 51
- Hard drive Connector 52
- Hard drive LED Connector 53
- Power Connector 53
- Expansion Slots 54
- ISA Bus Pin Assignments 55
- How to Set Jumpers 56
- Jumper Settings 57
- JP4 : CPU Clock Selection + 58
- Table B-4. DMA Channels Map 61
- Table B-5. Memory Map 61
- Table B-6. I/O Map 61
- Green PC Function 62
- Power Saving Block Diagram 63
- CPU Doze Mode 63
- System Standby Mode 63
- System Suspend Mode 63
- Award BIOS Setup 64
- Entering Setup 65
- SBC Configuration 66
- VGA Driver Utilities 67
- The BIOS Features Setup Menu 69
- Virus Warning 70
- Quick Power On Self Test 70
- Boot Sequence 70
- Boot Up Floppy Seek 70
- Boot Up NumLock Status 71
- Boot Up System Speed 71
- Gate A20 Option 71
- Typematic Rate Setting 71
- Typematic Rate (Chars/Sec) 71
- Chipset Features Setup 72
- DRAM Settings 73
- Cache Features 73
- PCI and IDE Configuration 73
- Power Management Setup 74
- Doze Mode 75
- Standby Mode 75
- PCI IRQ Activated by 76
- PCI IDE IRQ Map to 76
- Onboard PCI SCSI Chip 76
- Load BIOS Defaults 76
- Load Setup Defaults 76
- Integrated Peripherals 77
- Password Setting 77
- IDE HDD Auto Detection 78
- HDD Low Level Format 79
- Save & Exit Setup 80
- Canadian Limitations Notice 82
- Power Supply Unit 84
- Communication Module 84
- Carrier Card Expansion Card 84
- SITS/82/005S/D 85
- Compliance with BS6328 Part 1 85
- S0000122, Rev B 87
Relacionado con productos y manuales para Los componentes del chasis Multitech MVPGK1
(26 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.064 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales