Multitech MVPGK1 Guía de usuario descargar pdf (Pagina 17)

MultiVOIP Gatekeeper User Guide 17

Chapter 2 - Installation & Setup

Powering Up

Note: This is pluggable equipment; the socket outlet must be installed near the equipment and must

be easily accessible.

When connecting the equipment to the power-supply circuit, be sure to check equipment nameplate

ratings to avoid overloading circuits. Overloaded circuits may cause damage to over-current protection

devices and to power-supply wiring.

Make sure that the voltage selector on the power supply is set to the proper voltage prior to connecting

this equipment to the main power. If the voltage selector needs to be changed, an ordinary pencil can

be used to change the switch to the position which best correlates with the known input voltage. If the

voltage selector is in the "115" position, input voltages from 100-120VAC may be applied to the

equipment. If the voltage selector is in the "230" position, input voltages from 200-240 VAC may be

applied to the equipment.

Connect the power cord supplied with the CommPlete 4000 to the power cord connector on the back of

the cabinet and to an AC outlet. Press the power switch on the front of the cabinet to the ON position.

The power switch contains an LED which should light when power is applied.

Power Supply

120

Voltage Selector

Power Cord

Input

Monitor Power

Outlet

120

100M

LINK

ACT

Fig. 2-5. Power Supply Connectors

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 86 87

Sin comentarios

Multitech MVPGK1 Guía de usuario Pagina 17