Multitech MVPGK1 Guía de usuario Pagina 70
- Pagina / 87
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
MultiVOIP Gatekeeper User Guide 71
Appendix C - SBC Configuration Details
The parameters accessible on this screen govern the systems default speed, boot-up sequence,
keyboard operation, shadowing, and security.
Note: MultiTech presets all BIOS features before shipping the Gatekeeper. BIOS features should not be changed except
by expert operators.
Virus Warning
When this item is enabled, the Award BIOS will monitor the boot sector and partition table of the hard
disk drive for any attempt at modification. If an attempt is made, the BIOS will halt the system and the
following error message will appear.
! WARNING !
Disk boot sector is to be modified
Type Y to accept write or N to abort write
Award Software, Inc.
Afterwards, if necessary, you will be able to run an anti-virus program to locate and remove the
problem before any damage is done.
Enabled: Activates automatically when the system boots up. Causes a warning message to appear
when anything attempts to access the boot sector or hard disk partition table.
Disabled: No warning message will appear when anything attempts to access the boot sector or hard
disk partition table. (Default.)
NOTE: Many disk diagnostic programs which attempt to access the boot sector table can cause the above warning
message. If you will be running such a program, we recommend that you disable Virus Protection beforehand. When
enabled, this feature can cause problems when installing Windows 95.
CPU Internal Cache/External Cache
These two settings affect memory access speed, generally increasing access speed when enabled. The
default value is Enabled.
Enabled: Enable cache
Disabled: Disable cache
Quick Power On Self Test
This setting affects the duration of the Power On Self Test (POST), which occurs after you power up
the computer. If enabled, the BIOS will shorten or skip some check items during the POST.
Enabled: Enable quick POST (Default)
Disabled: Normal POST
Boot Sequence
This setting determines which drive to search first for booting files at startup. The default value is C, A.
C, A System will first search for a hard disk then a floppy disk drive.
A, C System will first search for a floppy disk drive, then for a hard drive.
Boot Up Floppy Seek
During POST, BIOS will determine if the floppy disk drive installed has 40 or 80 tracks. 360K type has
40 tracks while 760K, 1.2M and 1.44M are all 80-track devices.
Enabled: BIOS searches for the floppy disk drive to determine if it is 40 or 80 tracks. Note that BIOS
cannot tell from 720K, 1.2M or 1.44M drive type as they are all 80 tracks (Default).
Disabled: BIOS will not search for the type of floppy disk drive by track number. Note that there will
not be any warning message if the drive installed is 360K.
- MultiVOIP Gatekeeper 1
- Model MVPGK1 1
- Hardware User Guide 1
- User Guide 2
- Contents 3
- 6 Troubleshooting 35 4
- Appendices 45 4
- 1 Introduction/Description 5
- System Overview 6
- Technical Specifications 7
- SBC (Single Board Computer) 8
- Display: 9
- NIC Board (EN10100 PCI Card) 10
- Chapter 1 - System Overview 11
- 2 Installation and Setup 13
- Rack Mounting 15
- Cable Connections 15
- NIC Cabling 16
- SBC Board Cabling 16
- Powering Up 17
- 3 Single Board Computer 19
- Introduction 20
- Component Locations 21
- 4 PCI NIC Board 23
- About PCI Bus 25
- Features 25
- LED Indicators 26
- 5 Hardware Removal/ 27
- Replacement 27
- Card Cage Removal/Replacement 29
- GateKeeper 30
- Board Removal and Replacement 31
- Removing NIC Board 32
- 6 Troubleshooting 35
- Hardware Troubleshooting 36
- Chapter 6 - Troubleshooting 37
- Diagnostic Tests 38
- Calling Technical Support 39
- 7 Service, Warranty, and 40
- Technical Support 40
- Limited Warranty 41
- Ordering Accessories 42
- Tech Support 43
- About the Internet 43
- Appendices 44
- Pin Identification 45
- 6-Pin Circular Jack 46
- SBC Onboard Connectors 48
- Printer Port Connector 49
- COM 2 Port Connector 50
- Hard Disk Connector 50
- COM2 Connector 51
- External Keyboard Connector 51
- Reset Connector 51
- Floppy Disk Drive Connector 51
- Hard drive Connector 52
- Hard drive LED Connector 53
- Power Connector 53
- Expansion Slots 54
- ISA Bus Pin Assignments 55
- How to Set Jumpers 56
- Jumper Settings 57
- JP4 : CPU Clock Selection + 58
- Table B-4. DMA Channels Map 61
- Table B-5. Memory Map 61
- Table B-6. I/O Map 61
- Green PC Function 62
- Power Saving Block Diagram 63
- CPU Doze Mode 63
- System Standby Mode 63
- System Suspend Mode 63
- Award BIOS Setup 64
- Entering Setup 65
- SBC Configuration 66
- VGA Driver Utilities 67
- The BIOS Features Setup Menu 69
- Virus Warning 70
- Quick Power On Self Test 70
- Boot Sequence 70
- Boot Up Floppy Seek 70
- Boot Up NumLock Status 71
- Boot Up System Speed 71
- Gate A20 Option 71
- Typematic Rate Setting 71
- Typematic Rate (Chars/Sec) 71
- Chipset Features Setup 72
- DRAM Settings 73
- Cache Features 73
- PCI and IDE Configuration 73
- Power Management Setup 74
- Doze Mode 75
- Standby Mode 75
- PCI IRQ Activated by 76
- PCI IDE IRQ Map to 76
- Onboard PCI SCSI Chip 76
- Load BIOS Defaults 76
- Load Setup Defaults 76
- Integrated Peripherals 77
- Password Setting 77
- IDE HDD Auto Detection 78
- HDD Low Level Format 79
- Save & Exit Setup 80
- Canadian Limitations Notice 82
- Power Supply Unit 84
- Communication Module 84
- Carrier Card Expansion Card 84
- SITS/82/005S/D 85
- Compliance with BS6328 Part 1 85
- S0000122, Rev B 87
Relacionado con productos y manuales para Los componentes del chasis Multitech MVPGK1
(26 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.034 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales