Multitech MR9600-100 Guía de usuario descargar pdf (Pagina 53)

5 Security

Security Procedures

Setting up MultiCommManager security requires some planning before making changes. The

following sections will help you set up security for the first time.

How to Set up Security Modems and Modem Groups

1. First decide which modems should be security modems and what modem groups they

should be partitioned into, and create modem groups for them. This should reflect your need

to control access to different host types and access by users with different security levels.

Also consider what type of security modem (inbound, outbound, or both) each modem is

going to be.

Note: Chapter 4, “Organizing Your Modems” explains how to create modem groups and how

to put modems into them. If you need only one modem group, then you may want to create a

modem group just for your security modems instead of using the Unassigned modem group

as your modem group.

2. When the modem groups have been created, click on a modem group to select all the

modems in it, and select Setup| Modem|General to open the Modem General Setup dialog

box. Set the security type for all the selected modems.

3. Select Control|Load Modem Configuration to update the modems to their new settings as

security modems. Repeat this procedure until all of your modem groups have their security

type set correctly.

4. If you want your callback users to be able to select the host that calls them back, be sure to

enable the Host Selection feature for the site by selecting Setup| Modem|Security|Host

Select and enabling Allow Host Select in the dialog box.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 85 86

Sin comentarios

Multitech MR9600-100 Guía de usuario Pagina 53