Multitech MR9600-100 Guía de usuario descargar pdf (Pagina 70)

MultiCommManager User Guide

Fault and Status Messages

The following messages can be displayed in the Fault-Status window, in fault reports, or in the log

report. A subset of these messages can be found in fault alarm message boxes.

The Fault Analysis Report (Appendix A) provides a set of possible fault reasons. Listed below are

the descriptions and remedies for each fault reason.

Arcnet Error Controller may be down

Meaning: The Manager is unable to communicate with the controller.

Recovery: Make sure that the controller is not powered down, and that the connection

between the Manager and the controller has not been broken. If neither is the case,

restart Windows and the Manager.

Arcnet Send Error During Broadcast

Meaning: The Manager was unable to communicate with one or more controllers during a

broadcast message.

Recovery: Make sure that the controller is not powered down, and that the connection

between the Manager and the controller has not been broken. If neither is the case,

restart Windows and the Manager.

Attempt to use Black Listed Phone Number

Meaning: An attempt was made to enter a phone number in the list of illegal phone numbers.

The number falls into a range of blacklisted phone numbers.

Recovery: Remove the number from the black list. Change the wild card list.

Bad Password by user

Meaning: The password entered for the user was invalid.

Recovery: Verify or reset the user password.

Bad UserID

Meaning: An invalid user ID was entered at the user ID prompt.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 85 86

Sin comentarios

Multitech MR9600-100 Guía de usuario Pagina 70