Multitech CDMA Guía de usuario descargar pdf (Pagina 147)

ENHANCED IP STACK AT COMMANDS

147 AT Commands for EV-DO-EV3 Modems

Test command reports the supported range of values for the <cid> parameter only, in the format:

#DNS: (1)

Syntax

Command Command type

AT#DNS=<cid>,<primary>,<secondary> Set

AT#DNS? Read

AT#DNS=? Test

Parameters and Values

<cid> Context identifier.

1 Numeric parameter that specifies a particular PDP context definition.

<primary> String type, manual primary DNS server, in the format “xxx.xxx.xxx.xxx” used for

the specified cid. Use this value instead of the primary DNS server from the

network. Default: “0.0.0.0”.

<secondary> String type, manual secondary DNS server, in the format “xxx.xxx.xxx.xxx” used

for the specified cid. Use this value instead of the secondary DNS server from the

network. Default: “0.0.0.0”.

Notes

 If <primary> is ”0.0.0.0” and <secondary> is not “0.0.0.0”, then issuing AT#DNS=… raises an error.

 If <primary> is ”0.0.0.0” you are using the primary DNS server from the network as consequence of a context

activation.

 If <primary> is not ”0.0.0.0” and <secondary> is “0.0.0.0”, then only the manual primary DNS server is used.

 If the context identified by <cid> has not been activated, issuing AT#DNS= causes an error.

Socket Listen Ring Indicator #E2SLRI

Set command enables or disables the Ring Indicator pin response to a Socket Listen connect and, if enabled, the

duration of the negative going pulse generated on receipt of connect.

Read command reports whether the Ring Indicator pin response to a Socket Listen connect is currently enabled or

not, in the format:

#E2SLRI: <n>

Test command returns the allowed values for parameter <status>.

Syntax

Command Command type

AT#E2SLRI=[<n>] Set

AT#E2SLRI? Read

AT#E2SLRI=? Test

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 248 249

Sin comentarios

Multitech CDMA Guía de usuario Pagina 147