Multitech CDMA Guía de usuario descargar pdf (Pagina 59)

3GPP TS 27.007 AT COMMANDS

59 AT Commands for EV-DO-EV3 Modems

Calling Line Identification Presentation +CLIP

Set command enables or disables the presentation of the CLI (Calling Line Identity) of the calling party when

receiving a mobile terminated call.

Read command returns the presentation status of the CLI in the format:

+CLIP: <n>,<m>

where:

<n>

0 CLI presentation disabled.

1 CLI presentation enabled.

<m> Status of the CLIP service .

0 CLIP not provisioned.

1 CLIP provisioned.

2 Unknown (for Example no network is present).

Note: For compatibility with UC864, the value of <m> is returned.

This command issues a status request to the network, so it may take a few seconds to give the answer due to the

time needed to exchange data with it.

Test command returns the supported values for <n>.

Syntax

Command Command type

AT+CLIP=[<n>] Set

AT+CLIP? Read

AT+CLIP=? Test

Parameters and Values

<n>

0 Disables CLI indication. Default: 0.

1 Enables CLI indication.

If enabled the device reports after each RING the response:

+CLIP: <number>,<type>,””,128,<alpha>,<CLI_validity>

where:

<number> - String type, phone number of format specified by <type>.

<type> - type of address octet in integer format.

128 - both the type of number and the numbering plan are unknown.

129 - unknown type of number and ISDN/Telephony numbering plan.

145 - international type of number and ISDN/Telephony numbering plan. Contains the

character "+".

<alpha> - String type, alphanumeric representation of <number> corresponding to the

entry found in phonebook. Character set used is the one selected with command Select

TE character set +CSCS.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 248 249

Sin comentarios

Multitech CDMA Guía de usuario Pagina 59