Multitech CDMA Guía de usuario Pagina 75
- Pagina / 249
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
3GPP TS 27.007 AT COMMANDS
75 AT Commands for EV-DO-EV3 Modems
Parameters and Values
<n> Enable flag.
0 Disable +CME ERROR:<err> reports, use only ERROR report. Default: 0.
1 Enable +CME ERROR:<err> reports, with <err> in numeric format.
2 Enable +CME ERROR: <err> reports, with <err> in verbose format.
Notes
+CMEE has no effect on the final result code +CMS.
Reference: 3GPP TS 27.007.
Voice Control
DTMF Tones Transmission +VTS
Execute command allows users to send DTMF tone sequences.
Test command provides the list of supported <dtmf>s and the list of supported <duration>s in the format:
(list of supported <dtmf>s)[,(list of supported <duration>s)]
Syntax
Command Command type
AT+VTS=<dtmfstring>[,duration] Execute
AT+VTS=? Test
Parameters and Values
<dtmfstring> String of DTMF tones, which are ASCII characters in the set (0-9), #, * the string
can be 32 characters long. Tone duration is defined through the +VTD command.
Note: Input <dtmf string> without the double quotation mark (“”).
<duration> Duration of a tone in 1/100 sec. This parameter can be specified if only one ASCII
character is used in the dtmfstring.
0…5 A single DTMF tone is transmitted for a duration depending on the network, no
matter what the current +VTD setting is.
Notes
This command operates in voice mode only. See +FCLASS.
Reference: 3GPP TS 27.007 and TIA IS-101.
- EV-DO and CDMA 1
- Contents 3
- CONTENTS 18
- Introduction 19
- String Type Parameters 20
- Command Lines 20
- Command Response Timeout 22
- Command Issuing Timing 23
- Command Line Prefixes 26
- Hardware Revision #HWREV 28
- V.250 AT Commands 29
- Model Identification +GMM 32
- Capabilities List +GCAP 32
- Serial Number +GSN 33
- DTE Modem Interface Control 35
- Quiet Result Codes Q 36
- Response Format V 36
- Extended Result Codes X 37
- Flow Control &K 39
- Standard Flow Control \Q 39
- Ring (RI) Control \R 40
- Call Control 43
- Return to on-line mode O 44
- Answer A 44
- Compression Control 45
- S Parameters 45
- Ring Counter S1 46
- Escape Character S2 47
- Escape Prompt Delay S12 49
- Delay to DTR Off S25 49
- Error Control 50
- V.250 AT COMMANDS 51
- Reference: V.25ter 51
- 3GPP TS 27.007 AT Commands 52
- Multiplexing Mode +CMUX 54
- Network Service Handling 57
- Call Waiting +CCWA 60
- List Current Calls +CLCC 61
- Mobile Equipment Control 62
- Set Phone Functions +CFUN 63
- Signal Quality +CSQ 64
- Clock Management +CCLK 69
- Alarm Management +CALA 70
- Delete Alarm +CALD 72
- Alert Sound Mode +CALM 72
- Ringer Sound Level +CRSL 73
- Mobile Equipment Errors 74
- Voice Control 75
- Tone Duration +VTD 76
- General Configuration 77
- Message Format +CMGF 79
- Message Configuration 80
- Save Settings +CSAS 82
- Restore Settings +CRES 83
- List Messages +CMGL 86
- Read Message +CMGR 88
- PDU Mode 89
- Message Sending And Writing 91
- Notes PDU Mode 92
- Example PDU Mode 92
- Notes Text Mode 95
- Example Text Mode 96
- Delete Message +CMGD 97
- Custom AT Commands 99
- Software Shut Down #SHDN 101
- Extended Reset #Z 101
- Wake from Alarm Mode #WAKE 102
- Parameters and Values 103
- CUSTOM AT COMMANDS 104
- Example 106
- ATD Dialing Mode #DIALMODE 114
- Automatic Call #ACAL 114
- SMS Overflow #SMOV 117
- Audio Codec #CODEC 118
- Network Timezone #NITZ 118
- RTC Status #RTCSTAT 120
- Show Address #CGPADDR 121
- Cell Monitor #MONI 122
- Multisocket AT Commands 124
- Socket Info #SI 125
- Context Activation #SGACT 126
- Socket Shutdown #SH 127
- Socket Configuration #SCFG 128
- Socket Dial #SD 131
- Socket Restore #SO 132
- Socket Listen #SL 133
- Socket Listen UDP #SLUDP 134
- Socket Accept #SA 135
- Single Socket AT Commands 139
- FTP AT Commands 140
- FTP Close #FTPCLOSE 141
- FTP Put #FTPPUT 141
- FTP Get #FTPGET 141
- FTP Type #FTPTYPE 142
- FTP Read Message #FTPMSG 142
- FTP Delete #FTPDELE 143
- FTP List #FTPLIST 144
- Query DNS #QDNS 145
- Manual DNS Selection #DNS 146
- Firewall Setup #FRWL 148
- Data Volume #GDATAVOL 149
- ICMP Ping Support #ICMP 150
- PING Request #PING 150
- TCP Reassembly #TCPREASS 152
- E-mail SMTP Server #ESMTP 153
- E-mail Sending #EMAILD 157
- ENHANCED IP STACK AT COMMANDS 159
- GPS AT Commands Set 160
- GPS Reset $GPSR 161
- Command Command type 163
- AT$GPSACP Execute 163
- AT$GPSACP? Read 163
- AT$GPSACP=? Test 163
- Save GPS Parameters $GPSSAV 165
- Clear GPS Data $GPSCLRX 166
- GPS Lock Mode $GPSLOCK 166
- CDMA Custom AT Commands 168
- Syntax 170
- Modem NAM Parameters #ENG 171
- CDMA Notification #NOTI 173
- Mobile Station ID $MSID 176
- Service Status #SVCSTAT 177
- RM Interface Setting +CRM 181
- Data Session AT Commands 182
- Packet Zone ID +PZID 183
- Test Origination #TESTORI 184
- EVDO Specific AT Commands 185
- COMMANDS 186
- AUDIO COMMANDS 187
- Audio Commands 188
- Select Ringer Sound #SRS 189
- Select Ringer Path #SRP 190
- Tones Configuration 191
- Tone Classes Volume #TSVOL 192
- Headset Sidetone #SHFSD 196
- Handset Sidetone #SHSSD 197
- Audio Profiles 199
- Echo Canceller Configuration 203
- Digital Voice Interface 205
- Miscellaneous Audio Commands 205
- Examples 209
- RX AGC Enable #SRXAGC 211
- Verizon Specific AT Commands 214
- NAM Lock #NAMLOCK 217
- Read Message +VCMGR 217
- List Message +VCMGL 219
- Set Payload Length #SMSPSIZ 222
- Preferred Roaming List $PRL 224
- Reset $RESET 224
- Example 225
- Clear MRU Table #CLRMRU 226
- Mobile IP Commands 229
- Home Address $QCMIPHA 232
- Medium Data Rate $QCMDR 243
- AT Parser Abort 245
- CME Error List 246
- CMS Error List 247
- CMS ERROR LIST 248
- Acronyms 249
Relacionado con productos y manuales para Redes Multitech CDMA
Redes Multitech MTCMR-H Especificaciones
(12 paginas)
(12 paginas)
Redes Multitech MTR-H5 Guía de usuario
(26 paginas)
(26 paginas)
Redes Multitech MT100A2W Especificaciones
(16 paginas)
(16 paginas)
Redes Multitech MULTIVOIP MVP-130FXS Guía de usuario
(120 paginas)
(120 paginas)
Redes Multitech MTCBA-C-N12 Manual de usuario
(43 paginas)
(43 paginas)
Redes Multitech MT5600SMI Especificaciones
(138 paginas)
(138 paginas)
Redes Multitech MTCBA-C-IP-N12 Manual de usuario
(17 paginas)
(17 paginas)
Redes Multitech FaxFinder FF240-IP Manual de usuario
(23 paginas)
(23 paginas)
Redes Multitech MVP810-AV Manual de usuario
(4 paginas)
(4 paginas)
Redes Multitech MTCBA-C-U-N2 Especificaciones
(308 paginas)
(308 paginas)
Redes Multitech MTCMR-H Especificaciones
(56 paginas)
(56 paginas)
Redes Multitech CDMA Especificaciones
(129 paginas)
(129 paginas)
Redes Multitech MT2834BA Manual de usuario
(7 paginas)
(7 paginas)
Redes Multitech ISIHP-2U El manual del propietario
(63 paginas)
(63 paginas)
Redes Multitech MT2834BL Especificaciones
(225 paginas)
(225 paginas)
Redes Multitech MT56DSU-R Manual de usuario
(11 paginas)
(11 paginas)
Redes Multitech MTSMC-C-N3 Manual de usuario
(14 paginas)
(14 paginas)
Redes Multitech MT2834ZDX Manual de usuario
(20 paginas)
(20 paginas)
Redes Multitech MVP30-60 Manual de usuario
(4 paginas)
(4 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.044 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales