Multitech CDMA Guía de usuario descargar pdf (Pagina 156)

ENHANCED IP STACK AT COMMANDS

AT Commands for EV-DO-EV3 Modems

156

Parameters and Values

<da> String type, destination address.

<subj> String type, subject of message.

<att> Attached image flag. Not supported.

0 Don’t attach any image.

1 Attach the last snapshot taken.

The device responds to the command with the prompt '>' and waits for the

message body text.

To complete the operation send Ctrl-Z char (0x1A hex). To exit without writing the

message send ESC char (0x1B hex).

If e-mail message is successfully sent, the response is OK.

If message sending fails for some reason, an error code is reported.

Notes

 Ensure that no other commands are issued during command execution.

 To avoid malfunctions, wait for the OK or ERROR / +CMS ERROR:<err> response before issuing further

commands.

Example

AT#SEMAIL=”[email protected]”,”subject of the mail”

>message body… this is the text of the mail message…

CTRL-Z

..wait..

Message has been sent.

E-mail CDMA Context Activation #EMAILACT

Execute command deactivates and activates the CDMA context.

Read command reports the current status of the CDMA context for the e-mail, in the format:

#EMAILACT: <status>

where:

0 CDMA context deactivated.

1 CDMA context activated.

Test command returns the OK result code.

Syntax

Command Command type

AT#EMAILACT=[<mode>] Execute

AT#EMAILACT=? Test

1 2 ... 151 152 153 154 155 156 157 158 159 160 161 ... 248 249

Sin comentarios

Multitech CDMA Guía de usuario Pagina 156